CUBICLE WALL HEIGHT EXTENDERS - Made in USA

CUBICLE WALL HEIGHT EXTENDERS - Made in USA
Item# DPGP
$75.00 1 Pk
WIDTH: 

Cubicle Wall Height Extension Clear Vinyl Panels
25" Tall with Two Clamp-On Aluminum Stands
( 1 per Pack)

Light weight, no tools needed to install, attaches over the top of existing cubicle partitions using adjustable clamp. Easy to remove design provides flexibility when rearranging office spaces where social distancing is impractical, or facility modifications are cost prohibitive.

Comes in 4 standard widths matching popular cubicle wall partition lengths. For wider applications, multiple panels can be used



Item #
Width
Height
Price

DPGP2425

24 Inches

25 Inches

$ 75.00

DPGP6025

30 Inches

25 Inches

$80.00

DPGP3625

36 Inches

25 Inches

$ 85.00

DPGP4825

48 Inches

25 Inches

$ 95.00



LIGHT WEIGHT / NO TOOLS REQUIRED DESIGN
No tools needed for assembly or installation. Each panel comes with two aluminum clamps and poles that slide over the top of existing cubicle wall partitions. A thumb screw allows tightening to adjust for partition wall thicknesses from 1-1/2" to 2-3/4".

When not in use, the clear vinyl panels can be rolled up for compact storage until needed again. Can be cleaned with soap and water or with wipes.

CLEAR VINYL PANEL IS NFPA 701 AND UV RATED
To help meet typical fire code requirements for office partitions and furnishings, the clear vinyl panel material is NFPA 701 rated and the stands are made from metal. The panel is also UV 1,000 hr rated in case used in direct sunlight or outdoors.

COMBINE PANELS FOR WIDER SPACES
The base of each panel stand has extra holes allowing you to add a second upright pole to each clamp location. This allows panels to overlap in the middle without any gaps. note: 7/16" box wrench or adjustable wrench used to loosen nut holding pole to aluminum base clamp.)
Desktop

COMPACT STORAGE WHEN NOT IN USE
To store or relocate to different cubicle:
Simply slide the stands out of the panel edges.
Roll up the flexible vinyl panel.
(note: tabletop stands shown in picture below. Cubicle clamp base is 3" x 3" x 3" plus height of the pole.) Desktop
Made in USA